1. The taillights of the truck do not need to be trodden on the back of the frame with a deadweight of more than 3 tons. They should be laid flat.

2. The upper end of the taillight should be at least 250mm lower than the bottom of the slider.

Truck taillights of 3t and under 3t should be erected and the upper end should be at least 250mm lower than the bottom of the bracket.

4. The bottom plate of the car and the rear end channel steel connected with it shall be on the same level, and steps shall not be left.

5. The door buckle at the bottom of the cage shall be made into a bent hook, which shall be fixed on the corresponding holes of channel steel, and no protruding door buckle shall be made on channel steel.

6. The middle part of the tailgate is about 1,000mm and is completely empty.

Tailboard installation, tailboard installation, truck tailboard